Sine wave boost inverter

The boost inverter consists of two boost converters as shown in Fig 3(b). The output of the inverter can be controlled by one of the two methods: (1) Use a duty cycle D for converter A and a duty cycle of (1- D) for converter B. (2) Use a differential duty cycle for each converter such that each converter produces a dc-biased sine wave output.

The Modified Square Wave also known as the Modified Sine Wave Inverter produces square waves with some dead spots between positive and negative half-cycles at the output. The cleanest utility supply like power source is provided by Pure Sine Wave inverters.

The typical voltage source inverter (VSI) uses the topology, which has a characteristic that the average output voltage is always lower than the input dc voltage . Thus if an output voltage higher than the input one is needed, a boost dc-dc converter must be used between the dc source and inverters.

Among various possibilities, the solar cell is an instinct source of energy, which is increasingly being studied, researched and for conversion of electrical energy. In this paper we have studied dc to ac conversion technique using boost inverter with solar energy stored via PV cells in a battery as input.

The full bridge topology can, however, be used as a boost inverter that can generate an output ac voltage than the input dc voltage [4, 5]. Fig 2: Circuit used to generate an AC voltage larger than DC input voltage.

The method, in which the low voltage DC power is inverted, is completed in two steps. The first step is the conversion of the low voltage DC power to a high voltage DC source, and the second step is the conversion of the high DC source to an AC waveform using pulse width modulation.