Abkhazia solar water pump customization

When designing a solar pumping system, the designer must match the individual components together. A solar water pumping system consists of three major components: the solar array, pump controller and electric water pump (motor and pump) as shown in Figure 1.

The type of solar water pumping system: borehole/well (submerged), floating or surface will depend on the water source. If the source is a borehole (proposed or existing) or deep well, then a submersible pump that fits the borehole or well should be selected. If the water source is a river, then a surface pump should usually be selected.

There are many possible applications for solar water pumping, especially when considering that the pump can be combined with energy storage or other types of generation to make it more versatile. However, this guideline is related to solar only systems.

Based on a tilt angle of 18 degrees, the lowest ratio is 0.438 so June will be the design month. If this is finalised as the design month, the solar water pumping system must then be selected based on an irradiation of 4.38kWh/m2 and the required flow of 10 m3 or 10000 litres (2,642 gallons). angle. This is shown in Table 12

solar water pump manufacture/supplier will have tables or computer software which specify the flow from the solar water pumping system for various heads and solar irradiation. The “solar water pump designer” shall be capable of: Using the manufacturers data sheets or software to select the most appropriate solar water pumping system.

Solar pumping for village water supply systems Training Manual 50 Such days with too little water production can theoretically be overcome by installing more water storage capacity. In view of the very high costs of storage capacity, this is not an optimal solution.